EdgeOS VRRP
This How-To uses EdgeOS 1.7
Summary :
configure set interfaces ethernet ethX vrrp vrrp-group XXX virtual-address XXX.XXX.XXX.XXX/XX set interfaces ethernet ethX vrrp vrrp-group XXX priority XXX set interfaces ethernet ethX vrrp vrrp-group XXX preempt false set interfaces ethernet ethX vrrp vrrp-group XXX authentication type ah set interfaces ethernet ethX vrrp vrrp-group XXX authentication password ?????????? commit;save;exit
To create a virtual routing cluster using EdgeRouters (or any router that supports the protocol). The idea is that each router will have an interface IP and a shared virtual IP.
- R1 ETH0 -> 192.168.0.2
- R2 ETH0 -> 192.168.0.3
- VirtualIP -> 192.168.0.1
ssh into router 1 and use the following commands Replace the "X" with your environment's variables.
configure set interfaces ethernet ethX vrrp vrrp-group XXX virtual-address XXX.XXX.XXX.XXX/XX commit;save;exit
Then the same thing in the router2.
configure set interfaces ethernet ethX vrrp vrrp-group XXX virtual-address XXX.XXX.XXX.XXX/XX commit;save;exit
If both routers are on the same switch, they will work out who is master and who is backup. To designate this manually use the following commands on R1
set interfaces ethernet ethX vrrp vrrp-group XXX priority XXX commit;save;exit
(NOTE: The priority numbers range from 1-254, the higher the number the higher the priority) On R2
set interfaces ethernet ethX vrrp vrrp-group XXX priority XX commit;save;exit
In the event the master router goes down, the backup is running, and you don't want them to switch when the master comes back online; disable preemption on both routers.
set interfaces ethernet ethX vrrp vrrp-group XXX preempt false commit;save;exit
To secure the routing cluster from an unauthorized router joining them
set interfaces ethernet ethX vrrp vrrp-group XXX authentication type ah set interfaces ethernet ethX vrrp vrrp-group XXX authentication password ??????????
