Difference between revisions of "Wireguard"
Jump to navigation
Jump to search
Michael.mast (talk | contribs) |
Michael.mast (talk | contribs) |
||
| Line 20: | Line 20: | ||
<pre> | <pre> | ||
setenforce 0 | setenforce 0 | ||
| − | sed -i 's/ | + | sed -i 's/ELINUX\=enforcing/SELINUX\=disabled/' /etc/selinux/config |
</pre> | </pre> | ||
Revision as of 18:53, 5 May 2025
Rocky Linux
Dual NIC wireguard setup
Prerequisite Network Config
- Configure the firewall to only allow the wireguard port, then move the internal interface to the internal zone.
firewall-cmd --permanent --add-port=51820/udp --zone=public firewall-cmd --permanent --remove-service=dhcpv6-client --zone=public firewall-cmd --permanent --remove-service=cockpit --zone=public firewall-cmd --permanent --remove-service=ssh --zone=public firewall-cmd --permanent --zone=internal --change-interface=enp3s0 firewall-cmd --permanent --add-masquerade firewall-cmd --reload
- Enable forwarding
echo 'net.ipv4.ip_forward = 1' > /etc/sysctl.d/01-sysctl.conf sysctl -p
- Disable selinux because we are lazy
setenforce 0 sed -i 's/ELINUX\=enforcing/SELINUX\=disabled/' /etc/selinux/config
