Michael.mast: Created page with "I would never have found this out on my own as Ubiquiti is TERRIBLE about documentation and planning. However, considering they are 75% cheaper than everyone else I can give t..."

2016-11-11T18:05:33Z

Created page with "I would never have found this out on my own as Ubiquiti is TERRIBLE about documentation and planning. However, considering they are 75% cheaper than everyone else I can give t..."

New page

I would never have found this out on my own as Ubiquiti is TERRIBLE about documentation and planning. However, considering they are 75% cheaper than everyone else I can give them some room.
<br>
The following are the CLI commands needed to run on the access point. I was able to find the IP of the AP by using the unifi discovery tool.
#Then you ssh into the AP
#Tell it the url of the controller. As long as there is a route it can be found across subnets.
#Tell the controller to adopt the AP, it will remain in the adopting state until you tell the AP about the URL a second time.
#Type in the inform command again and you will lose access to the AP.
#Enjoy
<pre>
[ michael-ws Fri Nov 11 ] $ ssh ubnt@xxx.xxx.xxx.xxx
The authenticity of host 'xxx.xxx.xxx.xxx (xxx.xxx.xxx.xxx)' can't be established.
RSA key fingerprint is SHA256:XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX.
RSA key fingerprint is MD5:XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX.
Are you sure you want to continue connecting (yes/no)? yes
Warning: Permanently added 'xxx.xxx.xxx.xxx' (RSA) to the list of known hosts.
ubnt@xxx.xxx.xxx.xxx's password:

BusyBox v1.19.4 (2016-05-31 18:13:05 PDT) built-in shell (ash)
Enter 'help' for a list of built-in commands.

BZ.v3.4.19# mca-cli
UniFi# set-inform http://xxx.xxx.xxx.xxx:8080/inform

Adoption request sent to 'http://xxx.xxx.xxx.xxx:8080/inform'.

1. please adopt it on the controller
2. issue the set-inform command again
3. <inform_url> will be saved after device is successfully managed

UniFi# set-inform http://xxx.xxx.xxx.xxx:8080/inform

Adoption request sent to 'http://xxx.xxx.xxx.xxx:8080/inform'.

1. please adopt it on the controller
2. issue the set-inform command again
3. <inform_url> will be saved after device is successfully managed

UniFi# Connection to xxx.xxx.xxx.xxx closed by remote host.
Connection to xxx.xxx.xxx.xxx closed.
</pre>

Ubiquiti WAP Adaptation from different subnets - Revision history

Michael.mast: Created page with "I would never have found this out on my own as Ubiquiti is TERRIBLE about documentation and planning. However, considering they are 75% cheaper than everyone else I can give t..."